• News

  • Online Service

    Maritime-Hailey        
    Technical Service-Vin Hu
    Customer Service-Wendy
  • Sales Manager

    Sales Director-Jasper Lee
  • Technical Articles

    You are here: Home » News » Technical Articles
    Instruction for Automatic Parallel Cabinet [13/11/2014]

    Instruction for Automatic Parallel Cabinet Manual operation 1.1 Before starting, check if the phase sequence is correct. Before the phase sequence has been confirmed, the control switch (SA3) for the public part can’t switch. After the debug operations for the …

    DSE Module Selection Datasheet [30/09/2014]
    The Advantage of Genset Synchronizing Parallel Operation [29/09/2014]

    1. Improve the reliability and continuity of power supply system. As several genset synchronizing to one power system, make supply voltage and frequency more stability, and can bear larger load change. 2. Easy to maintenance. If several gensets are used …

    The Principle and Conditions of Genset Synchronizing [29/09/2014]

    The Principle of Genset Synchronizing Parallel Operation Automatic synchronizing system synchronizes two or more than two generator on the same bus-bar by automatic electric control devices. Each generator control panel has special equipment, and Shared equipment be placed in the output Cabinet. Power …

    Knowledge of the Ship Main Equipment Part (V) [25/09/2014]

    Knowledge of the Ship Main Equipment Part (V)  3.  Mooring Equipment When the ship is on the docks, away from the buoy, alongside other ship or towed, for mooring, warping equipment are collectively referred to as mooring equipment. Mooring equipment is composed …

    Knowledge of the Ship Main Equipment Part (IV) [25/09/2014]

    Knowledge of the Ship Main Equipment Part (IV)  2. Rudder Rudder is the main equipment of controlling ship, to maintain and heading direction during the voyage. It is mainly composed of rudder gear, servo, steering device and maneuvering gear and other equipment, …

    Knowledge of the Ship Main Equipment Parts (III) [25/09/2014]

    Knowledge of the Ship Main Equipment Parts (III) (3). Windlass Windlass machinery is used to throw anchor, heave up anchor, and pull back cable. The horizontal layout sprocket shaft Windlass is called horizontal windlass, which is general merchant uses windlass; the vertical …

    Knowledge of the Ship Main Equipment Parts (II) [25/09/2014]

    Knowledge of the Ship Main Equipment Parts (II) 7. Fresh Water Production Equipment Fresh water production equipment heat the sea water under the vacuum state to produce steam, and then the steam condenses into fresh water. 8. Automation System With the science …

    Knowledge of the Ship Main Equipment Parts (I) [25/09/2014]

    Knowledge of the Ship Main Equipment Parts (I) An operating ship must be equipped all kinds of equipments. Through these equipments, the ship can sail, berth and unberth, load and unload safely. The main equipments in the ship are power equipment, control …


    Copyright 2008-2023 EMAC International All Rights Reserved.
    Sitemap | Top↑